Download DA File FRP Removal File For Infinix X606/B. To Get Download Package, Click CONTINUE, Otherwise Click PREVIOUS PAGE. CONTINUE PREVIOUS PAGE. I need da file to reset frp on my infinix x606b. If need payement I must have sure payement way. Use the da of tecno ka7, it works on x606 (tested). Use cm2 v1.58 and replace the DA in boot folder.
Format A Single Partition In Infinix X604 using Infinix X604 Secure Boot DA File. This is a step by step guide showing how to format a single partition of an Infinix X604 using SP flash tool.
Why would I want to format a single partition on my Infinix X604?
There are different causes why one might want to format a single partition on an Infinix X604. One such example is when your device is FRP locked, all you need do is to format only FRP partition OR maybe you need to perform a factory reset but you are unable to boot into recovery mode for some weird unknown reasons, all you need is to format user data and cache partitions. The method below will show how we can do this.
Requirements to format one single partition on my Infinix X604:
- Supported Phone: Infinix X604
- Charge your mobile: You may no less than a half charge.
- Laptop or PC: To execute this installation, you must use a PC or Laptop.
Take Infinix X604 Backup:
Download Infinix X604 Flashing Tool And Drivers:
- Infinix X604 Flash Tool: Download the latest SP Flash tool and extract it (Install)
- Infinix X604 USB driver: Get VCOM Driver and set up on your pc (still works with MT67xx phones)
- Windows 10/Pro users: READ: How To Install MTK USB Vcom Driver On Windows 10 (32 & 64 bits)
Infinix X604 Secure Boot DA File Detail:
- File Name: S4 IX626B Boot DA
- Device Supported: Infinix X604
- Tool Supported: Sp Flash Tool
Download
How to Format a Single Partition of Infinix X604:
1. The steps below explain how to format a single partition of an Infinix X604 using SP flash tool.
2. Extract the content of the SP flash tool zip file and Launch SP flash tool.
3. Select the scatter file for your device by clicking choose besides the scatter-loading file’s dropdown bar.
4. In the windows that appear next, navigate to and select the Infinix X604 scatter file.
5. You should now be taken back to the SP flash tool window, click on the Format tab.
6. Tick the checkbox beside “Manual format flash”
7. Open windows explorer and navigate to the location of the scatter file you selected earlier on then open it using Notepad++
8. Scroll down the contents of the scatter file till you get to the partition you wish to format [in my case, I’m trying to format FRP partition]
9. Input the values of Linear_start addr and partition_size into SP flash tool then Click on Start
Linear_start addr = Begin Address
partition_size = Format Length
10. Power off the phone (with the battery in) then connect to the PC via a USB cord. Once successful, you should get a green tick.
11. Now you can boot up the Infinix X604.
Disclaimer:
- Once SP flash tool has detected your device, avoid disconnecting till the task is complete as this might cause the Infinix X604 to go dead.
- If you accidentally selected “Autoformat – Format all”, your device will go dead and you’ll need to flash full Infinix X604 stock ROM to revive the phone.
- Avoid using a random Infinix X604 scatter file (even though its for your chipset) in Sp flash tool. Just because a scatter file is for your chipset doesn’t mean it contains the same partition info. Formatting with a wrong scatter file could result in more problems than you initially intended to fix.
- SP flash tool was created by MediaTek Inc. so credits to them for the tool.